Table of Contents
Advertisement
InSERTInG.YOUR.REMOTE.
COnTROL'S.baTTERIES.
Insert the two batteries into your remote control .
Make sure you insert them the correct way round,
as shown by the + and – symbols in the battery
compartment .
REPLaCInG.THE.baTTERIES.In.YOUR.
REMOTE.COnTROL
•
Always replace both batteries at the same time .
•
Please dispose of batteries in an
environmentally-friendly way .
•
Used alkaline batteries must never be thrown
into a fire .
GettInG stARteD
SWITCHInG.On.YOUR.SET-TOP.
bOx
When you have connected your set-top box to
the mains supply, its indicator light, just below the
standby button (S), will light up .
If your set-top box is in standby, the light will be red;
if your set-top box is out of standby, the light will
be blue .
If the indicator light is red, switch on your TV, then
press the standby button (S) on the front panel of
your set-top box .
Whenever you are not using your set-top box, you
should put it into standby by pressing the standby
button (S) .
SWITCH-On.CHannEL.SETTInG
The factory setting for your set-top box is for it to
always tune to the last-viewed channel when you
bring it out of standby . You can change this setting,
so that your set-top box tunes to a specific channel
instead (see page 31) .
9
Advertisement
Table of Contents
