Table of Contents
Advertisement
VisuaLink 128/384 Quick Installation Guide
NDA-24232 Issue 2.0
7. Remove the rear panel from the VisuaLink housing.
8. Locate the AEC7M card. With a Phillips screwdriver remove three (3) screws
which attach the AEC7M card to the BRI interface.
Note: Two (2) of the three (3) screws are on the AEC7M. One (1) screw is on
the BRI board.
9. As the AEC7M and the BRI interface are connected at the front center of each
panel, pull the connectors apart, being careful not to break either unit.
Connectors
10.Locate the 384 IMUX card. Unpack the 384 IMUX card from the packaging
and place the card on a non-static bag.
Screw
Screws
Chapter 5
BRI Board
AEC7M
Board
Page 5-3
Advertisement
Table of Contents
