Table of Contents
Advertisement
VisuaLink Quick Installation Guide
NDA-24232 Issue 2.0
18. Plug Power Transformer into wall outlet, Plug other end of Power Transformer
into the POWER PORT of the NT-1 Device.
19. Take your Network Cable and plug one end into your provided BRI
NETWORK JACK (Wall) and plug the other end into the port marked U on
the NT-1 Device.
20. Take Network Cable (included with your VL128/384) and plug one end into
the S/T LINE port (either one) located on the NT-1 device.
21. Take the other end of VL provided Network Cable and insert it into S/T LINE
port located at the back of the VL128/384.
22. If installing a VL384 (Bypassing the PBX) then 3 NT-1 devices will be needed.
Steps 17 through 21 will need to be repeated.
23. Locate the Network Cable (RJ45-RJ45) and connect one end to the S/T LINE
port of the VL128/384. Connect the other end of the Network cable into the
NETWORK INTERFACE provided in the room. Proceed to Step 25.
Note: This step must be repeated 3 times if installing a VL384.
24. Connect the ST/LINE interface of the VL 128/384 into the WALL JACK.
25. Setup is complete.
Currently there are two ways to control and operate the VL 128/384. The first
type of control is using the wireless remote control unit. No matter which control
method is finally chosen, it is recommended that the wireless controller be used to
setup the VL. Proceed to the start up configuration procedure and return to this
section when completed.
The second type of control is through the PC. It is necessary to download the
director software from the Web (http://www.cng.nec.com). The Director software
will allow the VL to be controlled via the PC.
Chapter 6
Page 6-7
Advertisement
Table of Contents
