Table of Contents
Advertisement
VisuaLink 128/384 Quick Installation Guide
Chapter 5 Upgrading a VL 128 to a 384
5.1 Upgrade
Instructions
5.2 Apparatus
5.3 Hardware
Upgrade
Procedure
NDA-24232 Issue 2.0
This chapter contains instructions for upgrading your VisuaLink 128 system to a
VisuaLink 384. If you have any questions about the upgrade, please call your
video conference provider.
To upgrade your system, purchase the 384 upgrade kit (Stock # 0291421) from
video conference provider and follow the easy step-by-step instructions
mentioned below. When upgrading a system you must start with the Hardware
Procedure and finish up with Environmental Initialize.
384 Upgrade kit (Stock # 0291421)
Phillips Screw Driver (needed)
Grounding Strap (needed)
Note: The speed setting should be set to 2B (128 kbps). This will make sure the
upgrade is completed in a matter minutes instead of hours. When the
upgrade is complete, power OFF your system and continue on to the
hardware Upgrade Procedure.
All video cards are sensitive to electrostatic discharge. Slight discharges from
clothing or even from the normal work environment can adversely affect these
cards. By following these simple guidelines, however, you can minimize the
chance of damaging your video cards.
• Handle cards only by the non-conducting edges.
• Do not touch the card components or any other metal parts.
• Wear a grounding strap while handling the cards (if in a high static area).
• Ensure that the workstation is powered OFF before installing any
components.
1. If cables are connected to the rear of the system and are not labeled, label all the
cables. This will help to identify which cable is connected to which port when
the upgrade is complete.
2. Unplug all the all cables including the power cable, which is plugged into the
rear of the VL 128.
3. Strap on the Grounding Strap.
CAUTION
Chapter 5
Page 5-1
Advertisement
Table of Contents
