Table of Contents
Advertisement
Select
Display / Change
X
confirm.
The area to be avoided is indicated in the
map.
To change the location of the area: slide
X
the COMAND controller XVY, ZVÆ or
aVb.
The area is moved on the map.
To adjust the size of the area: turn
X
cVd the COMAND controller.
The area is enlarged or reduced.
To confirm the change: press W the
X
COMAND controller.
The list appears and the change is entered.
Deleting a set area
Select an entry in the list by turning cVd
X
the COMAND controller.
Select
Options
by sliding VY the
X
COMAND controller and press W to
confirm.
Select
Delete
and press W to confirm.
X
A query appears asking whether the entry
should be deleted.
Select
Yes
or No.
X
If you select Yes, the entry is deleted.
If you select No, the process will be aborted.
Off-road route memory function
Switching the function on/off
While this function is switched on, an off-road
route is recorded and stored.
i
Off-road: the section of route is still within
the area covered by the digital map but
does not contain any suitable data, e.g.
because a road has not been digitized.
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
and press W to
Select
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select
X
W to confirm.
Select
X
press W to confirm.
Depending on the previous state, switch
the option on O or off ª.
To exit the menu: slide XVY the COMAND
X
controller.
Displaying memory usage
When the memory is 90% full, you see a
message to this effect. You will also see a
message when the memory is completely full.
To confirm the message: press W the
X
COMAND controller.
i
In order to be able to continue using the
"Record route" function, you should delete
the route memory afterwards.
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select
X
W to confirm.
Select
X
press W to confirm.
The memory used is shown as a
percentage. The display closes
automatically after a few seconds.
Deleting the route memory
To switch on navigation mode: press the
X
Ø function button.
Additional settings
Navi
in the main function bar by
Save Off-road Route
Save Off-road Route
Navi
in the main function bar by
Save Off-road Route
Off-road Route Memory Used
95
and press
again and
and press
and
Z
Advertisement
Chapters
Table of Contents
