Table of Contents
Advertisement
Additional settings
94
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select
Navi
in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select
Block Area
X
confirm.
If you have not yet set any area to be
avoided, you will see the map with the
crosshair (option 1).
If you have previously set one or more areas
to be avoided, you will see a list (option 2).
Option 1: the map
To scroll the map: slide the COMAND
X
controller XVY, ZVÆ or aVb.
To set the map scale: as soon as you turn
X
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map, turning counter-clockwise zooms
in.
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
X
controller.
A red square appears on the map.
To adjust the size of the square: turn
X
cVd the COMAND controller.
The square is enlarged or reduced.
and press W to
To confirm the settings: press W.
X
The list appears. The previously selected
area to be avoided has been added and
activated.
Follow the instructions listed under "Option
X
2: the list".
Option 2: the list appears
Select
Avoid New Area
X
the COMAND controller and press W to
confirm.
The map with the crosshair appears.
Proceed as described under "Option 1: the
X
map" if you wish to set a new area to be
avoided.
Switching an avoided area on/off
Select an entry in the list by turning cVd
X
the COMAND controller and press W to
confirm.
The avoided area is switched on O or off
ª, depending on the previous status.
Displaying and changing an avoided
area
Select an entry in the list by turning cVd
X
the COMAND controller.
Select
Options
by sliding VY the
X
COMAND controller and press W to
confirm.
by turning cVd
Advertisement
Chapters
Table of Contents
