Conwol Settings; Freezing Up; Timer Control; Thermostat Control - GE AME18 Use And Care & Installation Manual

Operating Your Air Conditioner Controls
FAN
ONLY
OFF=
SELECTOR

Selector Switch

OFF turns air conditioner off.
FAN ONLY provides air
circulation without cooling.
NORMAL po.~ition.
LO COOL provides cooling with
low fan speed operation.
MED COOL provides cooling
with medium fan speed operation.
HI COOL provides cooling with
high fan speed operation.

Freezing up

Outside air
temperature
dropping
If vou notice that your air
conditioner is not-cooling as it
should, it may be that ice has formed
on the cooling coils. The ice blocks
air flow and stops the unit from
cooling the room. This "freezing up"
is a temporary condition that most
often occurs at night when the
Thermostat is set at a higher number
and the Selector is set on LO COOL.
To correct the condition, set the
Selector at HI FAN or HI COOL
warmest setting.
4
MED
COOL
-w-n-n-m-m-n-n-m-m

Thermostat Control

When you move the Thermostat
Control to the desired setting, the
thermostat will automatical& control
the temperature of the indoor air.
The higher the number selected, the
cooler the indoor air will become.
Energy Saver Fan
Cycle Switch
This switch
controls the
NORMAL
setting allows
continuous
fan function,
circulating air
even when the
compressor has
cycled off and
the thermostat
setting has been L.
setting is
maximum comfort.
SAVE setting lets the fan cycle on
and off with the compressor during
cooling. The fan stops when the
setting results in longer off time
and wider variations of room
temperature and humidity. This
setting is normally used when the
room is unoccupied.
THERMOSTAT
ENERGY SAVER
SAVE
recommended for
TIMER

Timer Control

(on models so equipped)
When you turn the Timer Control
to the MANUAL setting, the air
conditioner starts immediately and
operates continuously if the
Selector Switch is at any setting
other than OFF.
When used with the Delay
Control turns the air conditioner
on or off at preset times.
To delay the start of the air
conditioner anywhere from
1 to 12 hours:
1. Set the Timer Control for the
number of hours you want to delay
the start of the air conditioning
operation.
DELAY START
2. Set the Delay
at DELAY START.
3. Turn the
Selector Switch to
the desired setting. k
To stop the air conditioning from
1 to 12 hours later:
1. Set the Timer Control for the
number of hours you want the air '
conditioner to operate before
shutting off automatically.
2. Set the Delay SttiStop Switch at
DELAY STOP.
3. Turn the Selector Switch to the
desired setting.
—