Table of Contents
Advertisement
4. INSTALLATION
4.1. HANDLING, TRANSPORT AND STORAGE
TRANSPORT AND STORAGE
WARNING !
!
FORKS OF HIGH LIFTING TRUCK MUST HAVE SUFFICIENT LENGTH (SEE FIG. 4.1.A).
Use a lift truck or a manual skid cart for handling with the machine in transporting package.
– The ambient temperature of transportation and storage must be between -25°C / -13°F and +55°C / 131°F.
The machine may not be installed within the reach of spraying water. Avoid severe climatic conditions and
excessive humidity. When steamed up due to the temperature to the temperature changes, water must
not run over the walls and covers of the machine nor to cover the floor under and around it.
– If possible, leave the machine in the transporting package or at least let it set on the transporting wooden
skid until the time of final installation on the foundation according the chapter 4.3. of this manual.
22 kg
33/40/55 kg
1100 mm
1500 mm
50 lbs
80/100/125 lbs
44"
59"
Fig. 4.1 A Minimum length „X" of lift truck forks for individual machine types including package
HANDLING DURING INSTALLATION
All activities can be done only by a worker, which knows all information about the machine. Machine is
delivered to the customer in a wooden packing and protected with polyethylene film. The machine is
attached to the skid by means of four bolts M16 (for machine 22 kg / 50 lbs capacity: M12).
To remove the machine to its final location follow these precautions:
– All passages and spaces the machine has to be transported through at installation should be reasonably
dimensioned to meet the height and width of the machine including the package.
– Never push, pull or press the components protruding from the contour line of machine (front part,
filling door, control elements, belt cover, water inlet and outlet pipes etc.).
MAKE SURE THAT THESE COMPONENTS ARE SECURED SO AS TO AVOID THEIR DAMAGE
DURING HANDLING AND INSTALLATION OF THE MACHINE.
– Make sure that the filling door are secured to avoid its opening during the handling.
– Lift the machine up by lift truck using a transport skid to which the machine has been attached.
UNPACKING
After unpacking, check if the machine has not been damaged and if all the accessories are included
according to your order. Verify the type of your machine by a name plate located on the machine rear and
find corresponding information in the manual. The accessories and the manual is located inside of the drum,
which can be opened according to chapter 6.1.
Before the machine locating to its place, remove the packaging, loosen four nuts and lift the machine
carefully up - take care not to damage the machine components located in its lower part. The lift truck forks
must be at least 10 cm longer than the length of the washing machine frame (tab. 4.1.).
Tab. 4.1. Minimum length „X" of a lift truck forks for individual machine types without packing
14
22 kg
33 kg
1100 mm
1222 mm
50 lbs
80 lbs
44"
48"
INSTALLATION AND MAINTENANCE MANUAL
40 kg
55 kg
1322 mm
1502 mm
100 lbs
125 lbs
52"
59"
PUBLICATION DATE 03/02
504 766
Hide quick links:
Advertisement
Table of Contents
