Mixed Size Stapling - Kyocera 5550ci Operation Manual

Use the procedure below to produce stapled copies.
Staple/Punch
Staple
Off
Punch
Original : A4
Off
Zoom : 100%
:
Paper A4
Preview
Add Shortcut
Status

Mixed Size Stapling

Even with mixed paper sizes, if the sizes have the same width or same length as shown in the combinations
below, the output can be stapled. The maximum number of sheets that can be stapled is 30.
A4 A3
B5 B4
Letter Ledger
A4 A3
B5 B4
Letter Ledger
Letter-R Legal
Letter-R Legal
Copies
Top 2 staples
Left Top
Top 2 staples
Right Right
2 staples Saddle
Left Stitch
2 holes 3 holes
Left Left
Top Edge
2 holes 3 holes
on Top
Top Top
Original
2 holes 3 holes
Orientation
Right Right
Cancel OK
10/10/2010 10:10
1
Press the Copy key.
2
Place the originals on the platen.
NOTE:
When performing Mixed Size Stapling, refer to
Mixed Size Originals on page 4-6.
3
Press [Org./Paper/Finishing] and then [Staple/
Punch].
4
Select the staple position.
NOTE:
To use saddle stitching, press [Saddle Stitch].
When placing originals, be sure to place the cover
page at the bottom. For more information on saddle
stitching, refer to Booklet from Sheets on page 4-20.
5
Press [Original Orientation] to choose orientation of
the originals, either [Top Edge on Top] or [Top Edge
on Left]. Then press [OK].
6
Press [OK].
7
Press the Start key. Copying begins.
• A3 and A4
• B4 and B5
• Ledger and Letter
• Ledger and Letter-R
• 8K and 16K
3-20
Basic Operation