Maytag MAH22PDAGW0 Installation Instructions Manual page 12

CODE EXPLANATION
A. 00 VAULT VIEWING OPTION
This option is either SELECTED "ON" or NOT
SELECTED "OFF."
A. 00 Not Selected "OFF."
A. SC Selected "ON." Press the DELICATES & KNITS key
pad once for this selection. When selected, the
money and/or cycle counts will be viewable (if
counter option(s) is selected) when the coin box is
removed.
Press the WOOLENS key pad once to advance
to next code.
b. 05 VALUE OF COIN 1
b. 05 This represents the value of coin 1 in the quantity of
5% increments of the larger coin value. 5 x
5%=25%.
By pressing the PERMANENT PRESS key pad,
there is the option of 1-199 for the quantity of 5%
increments.
With coin slide activation, this represents the total
vend price.
Press the WOOLENS key pad once to advance
to next code.
C. 20 VALUE OF COIN 2
C. 20 This represents the value of coin 2 in the quantity of
5% increments of the larger coin value. 20 x
5%=100%.
By pressing the PERMANENT PRESS key pad,
there is the option of 1-199 for the quantity of 5%
increments.
C. 05 PN MODELS: This represents the value of coin 2 in
the quantity of 5% increments of the larger coin
value. Factory default = 5 x 5% of the larger coin
value.
Press the WOOLENS key pad once to advance
to next code.
d. 00 COIN SLIDE OPTION
This option is either SELECTED "ON" or NOT
SELECTED "OFF."
d. 00 Not Selected "OFF." Used with coin drop or card
readers.
d. CS Selected "ON." Press the DELICATES & KNITS key
pad 3 consecutive times for this selection.
NOTE: This option needs to be set to"00" unless
the meter case has been changed to accept a
coind slide device.
When coin slide mode is selected "On", set b.
equal to value of vend price. Set set-up code 6
(regular cycle price) and set-up code 3 (special
cycle price) to number of slide pushes. If washer is
set up as "CS" and a coin drop is installed, it will
not register coins.
Press the WOOLENS key pad once to advance
to next code.
12
CODE EXPLANATION
E. 00 ADD COINS OPTION
This option is either SELECTED "ON" or NOT
SELECTED "OFF." This option causes the customer
display to show the number of coins (coin 1) to
enter, rather than the amount.
E. 00 Not Selected "OFF."
AC Selected "ON." Press the DELICATES & KNITS key
pad 3 consecutive times for this selection.
Press the WOOLENS key pad once to advance
to next code.
F. 00 ENHANCED PRICING OPTION
F. 00 Not Selected "OFF."
F. CP Cycle-Based pricing enabled. This option allows
configuration of different prices for cold, warm, and
hot water cycles.
F. Su Super Cycle pricing enabled. This option allows
customers to upgrade cycles by depositing extra
money. Set-up codes "H." and "h." will be
displayed only when this option is enabled. Press
the DELICATES & KNITS key pad once for this
selection.
Press the WOOLENS key pad once to advance
to next code.
H. 01 SUPER CYCLE UPGRADE PRICE
(Skipped unless super cycle pricing is enabled.)
H. 01 This represents the number of coin 1 required
to upgrade a base cycle to a super cycle. Advance
from 0-39 by pressing the PERMANENT PRESS
key pad.
Press the WOOLENS key pad once to advance
to next code.
h. 01 SUPER CYCLE TYPE
(Skipped unless Super Cycle pricing is enabled.)
h. 01 This represents the super cycle upgrade option.
Press the PERMANENT PRESS key pad to step
through upgrade options 1-3 as follows:
01 - enhanced wash, extra 3 minutes of wash
tumble in addition to the programmed wash time.
02 - extra rinse for all cycles.
03 - both 01 and 02.
Press the WOOLENS key pad once to advance
to next code.
J. Cd COIN/DEBIT OPTION
J. Cd Both coin & debit selected. Press the DELICATES &
KNITS key pad 3 consecutive times to change this
section.
J. C_ Coins selected, debit disabled. Press the
DELICATES & KNITS key pad 3 consecutive
times to change this selection.
J. _d Debit card selected, coins disabled. This is
the factory default for PN models. Press the
DELICATES & KNITS key pad 3 consecutive
times to change this selection.
J. Ed Enhanced Debit is self-selected when a Generation
2 card reader is installed in the washer. The Ed
option cannot be manually selected or deselected.
Press the WOOLENS key pad once to advance
to next code.