Drain System - Maytag MAH22PDAGW0 Installation Instructions Manual

■ A sturdy and solid floor to support the washer with a total
weight (water and load) of 180 kg (400 lbs).
Do not operate your washer in temperatures below 0°C (32°F).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
■ The location must be large enough to allow the washer door
to be fully opened.
■ Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90°
and it is not reversible.
■ Additional clearances might be required for wall, door, and
floor moldings.
■ Additional spacing of 25 mm (1") on all sides of the washer
is recommended to reduce noise transfer.
■ Companion appliance spacing should also be considered.
■
When installed, the mains plug should be accessible for
washer disconnection from the mains supply.
Washer Dimensions
1282 mm
1 /
(50 ")
2
Door is not reversible.
A floor drain should be provided under the bulkhead.
Prefabricated bulkheads with electrical outlets, water
inlet lines, and drain facilities should be used only where
local codes permit.
686 mm
(27")
1134 mm
5 /
(44 ")
8
732 mm
(28 13 / ")
16

Drain System

The washer can be installed using the standpipe drain system
(floor or wall), the laundry tub drain system, or the floor drain
system. Select the drain hose installation method you need.
See "Tools and Parts."
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
The top of the standpipe must be at least 762 mm (30") high and
no higher than 2.4 m (96") from the bottom of the washer.
A
Laundry tub drain system (view C)
The laundry tub needs a minimum 76 L (20 gal.) capacity. The top
of the laundry tub must be at least 762 mm (30") above the floor.
Floor drain system (view D)
The floor drain system requires a siphon break that may be
purchased separately. See "Tools and Parts."
The siphon break must be a minimum of 710 mm (28") from the
bottom of the washer. Additional hoses might be needed.
762 mm
(30" min.)
C
762 mm
(30" min.)
B
710 mm
(28" min.)
D
5