Light Bulb Replacement - GE Side by Side 22 Dispenser Use And Care Manual

Light Bulb Replacement

Fresh Food Compartment-Upper Light
1. Unplug refrigerator.
2.
To align the control knob properly, note position
of numbered control for proper reassembly, turn
control to OFF and pull off knob.
3. Pull bottom of light panel down about l/4''—just
enough to disenguge lip at rear from grooves in
retainers on rear wall.
4. Lift panel to disengage top from pins on side walls;
remove panel.
After replacing with same size bulb, reinstall panel
(hang top on pins; pull bottom down, push it back and
release it to let lip engage grooves in retainers).
Replace temperature control knob in OFF position, turn
it to previous setting, and plug refrigerator back in.
Behind Refrigerator
Care should be taken in moving your refrigerator
away from the wall. All types of floor coverings can
be damaged, particularly cushioned coverings and
those with embossed surfaces. Pull the refrigerator
straight out and return it to position by pushing it
straight in. Moving your refrigerator in a side
direction may result in damage to your floor
covering or refrigerator.
Fresh Food Compartment-Lower Light
(on some models)
This light is located behind a shield at the rear of the
fresh food compartment.
1. Unplug refrigerator.
2. Grasp the top edge of the shield and lift it up and
forward to free its top edge.
3. After replacing with the same size bulb, hook the
top of the shield back in place.
In Freezer Compartment
1. Unplug refrigerator.
2. Remove shelf just below light
shield. (Shelf will be easier to
remove if it is emptied first.)
3. Pull plastic light shield toward
you. (It will bend to free tabs
from grooves.)
After replacing with same size
bulb, reinstall shield and shelf
and plug refrigerator back in.
When pushing the refrigerator back, make sure
you don't roll over the power cord or icemaker
water supply line.
—