Care And Cleaning; Cleaning The Outside; Moving The Refrigerator; Light Bulb Replacement - GE 15 Owner's Manual And Installation Instructions

Care And Cleaning

Cleaning the Outside

The door handles and trim (on some models). Clean with
dampened with kitchen appliance wax or mild liquid dish
wet towel. These may leave a residue that can erode
bleach or cleaners containing either bleach or ammonia
because these products can scratch and weaken the
paint finish.
The stainless steel doors and door handles (on some
models) can be cleaned with a commercially available
stainless steel cleaner. Cleaners with oxalic acid such as
cleanser free of grit and rub in the direction of the brush
or polish on the stainless steel.

Cleaning the Inside

To help prevent odors, leave an open box of baking soda
practical, wring excess moisture out of sponge or cloth
when cleaning around switches, lights or controls.
tablespoon (15 ml) of baking soda to a quart (1 liter) of
wipe dry.
After cleaning the door gaskets, apply a thin layer of
petroleum jelly to the door gaskets at the hinge side.
This helps keep the gaskets from sticking and bending
out of shape.
CAUTION
with warm water when they are cold. Glass shelves and
covers may break if exposed to sudden temperature
changes or impact such as bumping or dropping.
Tempered glass is designed to shatter into many small
parts in the dishwasher.
To Clean the AutoFill Pitcher
should be placed in the top rack only and the pitcher in
the bottom rack of the dishwasher. Run on normal wash.
recommended that you rinse it thoroughly after washing
has been in contact with food that is likely to cause
discoloration (e.g. tomato ketchup, mustard), clean your
pitcher promptly. This is to avoid possible discoloration
of your pitcher.
49-60801
to our website at www.geapplianceparts.com.

Moving the Refrigerator

Be careful when moving the refrigerator away from
the wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces.
Turn the leveling legs at each front corner of the
refrigerator counterclockwise until the rollers support
the refrigerator. Pull the refrigerator straight out and
return it to position by pushing it straight in. Moving the
refrigerator in a side direction may result in damage to
the floor covering or refrigerator.
When pushing the refrigerator back, make sure you don't
roll over the power cord or ice maker supply line (on
some models).
After rolling the refrigerator back into place, turn the legs
clockwise until the legs again bear the weight of the
refrigerator.

Light Bulb Replacement

WARNING
Before replacing a burned-out light
bulb, the refrigerator should be unplugged in order to
avoid contact with a live wire filament. (A burned-out light
bulb may break when being replaced.)
power to the light circuit.

Preparing for Vacation

the refrigerator. Move the temperature control dial to the
solution of one tablespoon (15 ml) of baking soda to one
quart (1 liter) of water. Leave the doors open.
model, and shut off the water supply to the refrigerator.
qualified servicer drain the water supply system (on
some models) to prevent serious property damage due
to flooding.
Preparing to Move
Secure all loose items such as grille, shelves and
drawers by taping them securely in place to prevent
damage. To prevent the doors from opening while
moving, secure them to the case with tape. Be sure the
refrigerator stays in an upright position during moving.
9