Light Bulb Replacement - GE Export G-Line Use And Care Manual

Light Bulb Replacement

Fresh Food Compartment—Upper Light
1. Unplug the refrigerator.
2. For easiest reassembly move the
knobs to their lowest setting, then
pull off the knobs
3. Pull the light shield down and
forward, then rotate the top up and
off. After replacing with same size
bulb, reinstall light shield and set
the knobs to the position that they
were at before; or set both knobs
at "5". If you cannot locate the
correct bulb, see your dealer.
4. Plug the refrigerator back in.
Fresh Food Compartment—Lower Light (on some models)
This light is located either behind the top drawer or right above the top
drawer (depending on your model).
1. Unplug the refrigerator.
2. If the light is behind the top drawer you will need to remove the
drawer and the shelf above it. To remove the drawer see the Drawer
Removal section in Care and Cleaning.
• To remove the shelf first
remove any food on the shelf.
Then tilt the shelf up at the front
and lift it up and out of the
tracks.
3. Grasp the bottom of the light
shield and pull it forward and up.
4. After replacing with the same size
bulb, replace the shield. If you
cannot locate the correct bulb, see
your dealer.
5. If the light was behind the top drawer, you will need to replace the
drawer and the shelf above it.
• To replace the shelf, raise the shelf front slightly and place the top
hooks in the lowest large track slots. Then lower the front of the
shelf until it is level.
6. Plug the refrigerator back in.
14
CARE AND CLEANING
(continued)
Refreshment Center (on some models)
1. Unplug the refrigerator.
2. Open fresh food compartment door,
3. Press sides of flexible light shield to
4. Unscrew burned-out bulb and replace it with appliance light bulb of
5. Place rear tab of light shield into door and rotate shield up until tabs
6. Plug refrigerator back in.
Freezer Compartment with a Dispenser
1. Unplug the refrigerator and
2. Remove the screw holding the light
3. Shift the shield to the left to free the
4. After replacing with same size bulb,
5. Plug the refrigerator back in.
Freezer Compartment with no Dispenser
1. Unplug the refrigerator and
2. Remove the two screws holding
3. Pull the light shield toward you
4. After replacing with same size
5. Plug the refrigerator back in.
remove top bin and raise Refreshment
Center inner door.
release locking tabs and allow the
shield to swing down.
same wattage. If you cannot locate the correct bulb, see your dealer.
lock into slots above.
remove the ice bin.
shield in place.
tabs, then lower it.
hook the shield in place and replace
the screw. If you cannot locate the
correct bulb, see your dealer.
remove the top shelf.
the light shield in place.
to reach the bulb.
bulb, hook the shield in place
and replace the screw. If you
cannot locate the correct bulb,
see your dealer.
Screw
Screws