Drawer And Cover Removal; Condenser - GE Side by Side 22 Dispenser Use And Care Manual

Condenser

For most efficient operation, you need to keep the
condenser clean. Remove the base grille and either
sweep away or vacuum up dust that is readily accessible.
For best results, use a brush specially designed for
this purpose. It is available at most appliance parts
stores. This easy cleaning operation should be done at
least once a year.

Drawer and Cover Removal

Drawers will stop before coming all the way out of
refrigerator to help prevent contents from spilling
onto floor. Drawers can easily be removed by tilting
up slightly and pulling past "stop" location.
To remove drawers when the fresh food
compartment door cannot be opened fully:
1. Remove food from the shelf above the Moist 'n
Fresh drawer and take out the shelf. Take food off
of the glass cover and out of the drawer.
2. Remove the flexible Drawer
gasket at the rear of
the Moist 'n Fresh
drawer. Lift each end
straight up until the
slots on the gasket are
free of the drawer
tabs.
3. Pull the drawer
in,
partway out. Reach
push the rear of the
glass up and, at the
same time, push it
back until it clears the
front corner retainers.
4. Tilt and remove the cover.
Pull the drawer
5.
forward, lift the front
to clear stops, and
remove the drawer. If
the refrigerator door
doesn't open
completely, pull the
drawer out until it hits
the door. Then lift the
drawer up until it is higher than than the drawer
supports, tilt it and take it out.
14
(continued)
F
supports, remove the tape. Pull drawer partway out.
Reach in, push the rear of the glass up and, at the
same time, back, until it clears front-corner retainers.
7. Tilt and remove the
cover. Avoid cleaning
the cold glass cover
with hot water
because the extreme
temperature difference
the drawer.
After cleaning,
replace in reverse
order. When
replacing the
drawer make sure
you slide it
through both
drawer guides on
the left side.
vegetable drawer.
Fit the ~nd ~Jf the
plastic drawer
support into the
slot on the gasket,
with the rubber
gasket flap facing
you. Make sure
into place.
I
w