Light Bulb Replacement - GE TBI18JIBPRWW Use And Care & Installation Manual

Two Drawers
(on some models)
1. Remove the drawer farthest
from the door.
2. Remove the other drawer.
On models with a bottom
door shelf that blocks the
other drawer, slide the other
drawer toward the middle
and remove it.
3. Remove the glass cover. Reach
in, push the front of the glass
cover up and, at the same time,
pull it forward as far as it will
come. Tilt it and take it out.

Light Bulb Replacement

A light bulb and socket are located at the top of the fresh food
compartment opposite the temperature control panel.
Some models also have a bulb and socket in the upper left corner of
the frozen food storage compartment behind a removable light shield.
To replace either bulb, unplug the refrigerator from its electrical
outlet and remove the light shield by pulling down on the shield at
the bulb end. When the bulb cools, unscrew it and replace it with a
similar size bulb.
10
CARE AND CLEANING
(continued)
4. Remove the drawer frame
To replace:
1. Lower the frame until it rests
2. Replace the drawers.
a. Slide one side of the drawer
b. Move the slide and drawer all
c. Slide the other drawer into place.
3. Replace the glass cover, pushing its rear edge firmly into the rear
When replacing the light
shield make sure the tab
is placed in the groove
of the light shield holder.
Then rotate the shield
back and up until the
shield snaps into place.
(Always remove the glass
cover before you take out the
drawer frame.)
Lift the frame off the supports
at each side and back, pull it
forward, tilt it and take it out.
on the supports at each side
and back.
If you removed the drawer slide,
replace it with the sloped end at
the front.
onto the drawer slide.
the way to the hinge side until
the other side of the drawer rests
on the frame.
frame channel and gently lowering the front into place.
Frame
Drawer Slide
(sloped end)
Groove
Tab