Dispenser - GE Side by Side 22 Dispenser Use And Care Manual

Before Using Your Icemaker and Dispenser
you use your refrigerator before
If
the water connection is made, raise
the ice access door and make sure
the icemaker feeler arm is in the
STOP (up) position.
arm in
(up)
position
Once Your Icemaker and Dispenser are in Operation
Throw away the first few batches of ice cubes (16 or
24 cubes). This will flush away any impurities in the
water line. Do the same thing after vacations or
extended periods when ice isn't used.
On models with a water dispenser, pour the first six
line. The first water through the system picks up a slight
"plastic" taste from the water tubing.
To make sum the bin fills with ice, level the cubes
When
occasionally. cubes fdl into the bin they may pile
up close to the icemaker and push the feeler arm to the
STOP position before the bin gets full. Keeping the
cubes level allows the icemaker to fill the bin.
To Dispense Ice and Water
or WATER (on some models).
6
(continued)
m in
n)
position

Dispenser

pad
When the water supply has been connected to the
icemaker, move the feeler arm to ON (down) position.
On models with a water dispenser, select water then
press the dispenser pad for about two minutes to
remove trapped air from the water line and to
The ice cube mold automatically fills with water after
cooling to freezing temperatures. First cubes normally
freeze after several hours.
NOTE: With a newly-installed refrigerator, allow
about 24 hours for the freezer compartment to cool
down to the proper ice-making temperature.
Caution:
Under certain rare circumstances, ice cubes may be
discolored, usually apparing with a ~n-bluish
color. The cause of this unusual discoloration is
apparently due to a combination of factors such as
certain characteristics of locrd waters, household
plumbing and the accumdation of coppr sahs in an
inactive water supply line which feeds the icemaker.
Continued consumption of such discolored i~ cubes
may be injurious to health. H such discoloration is
observed, discard the ice cubes and contact your GE
Factory Service Center or an authorized Customer
@
Care Servicer.
Grip the glass or other container near the rim and
press the rim against the center of the dispenser pad.
Dispenser
pad