How To Operate Your Dishwasher - GE HDB727K Use And Care Manual

How to operate your dishwasher

STEP 1. Load your dishwasher
with dishes, silverware, pots, pans,
bowls, etc. according to
instructions on pages 8 and 9.
STEP 2. Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator Dial is at OFF
position before adding detergent.
See pages 6 and 7.
Use rinse aid agent to help prevent
spotting. See page 6.
Connect Unicouple and electricity
according to instructions on pages
11 and 12.
STEP 3. Select DRYING HEAT
Option. It must be ON for PLATE
WARMER cycle, OFF for RINSE
HOLD cycle. It can be ON or OFF,
at your option (see below), for any
of the wash cycles.
DRYING
HEAT OFF
HEAT ON
1
DRYING HEAT ON. Turns the
drying heater on for fast drying.
DRYING HEAT OFF. Turns the
drying heater off to save energy.
Dishes will dry naturally over a
longer period such as overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
model approximately 10% for
the NORMAL WASH cycle.
STEP 4. Select the Cycle and start
dishwasher.
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher. (See Cycle
selection hints on next page.)
To obtain the benefits of a complete
cycle, be careful that you do not
turn the dial any further than
necessary to start the dishwasher.
For NORMAL WASH cycle:
a. Latch the door.
b. Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
4
Cycle Indicator Dlai
Door Latch
For LIGHT WASH cycle:
a. Be sure door is unlatched.
LIGHT WASH
ON 8
OFF W
@~
b. Slowly turn Cycle Indicator Dial
to LIGHT WASH position.
c. Latch door to start the cycle.
For RINSE HOLD cycle:
a. Be sure door is unlatched.
b. Select DRYING HEAT–OFF
drying option.
LIGHT WASH W
ON
OFF
S1 1 turn Cycle Indicator
OW Y
c.
Dial t~ RINSE HOLD position.
d. Latch door to start the cycle.
. RINSE ~::~~
HOLO
.
. RINSE ~::