GE HDB727K Use And Care Manual page 12

How tome the Uticouple
Before operating your
Attach the Aerator Wucet Adapter.
The special aerator faucet adapter
supplied with your dishwasher must
be assembled to the sink faucet
before you can use your dishwasher.
The faucet adapter is designed to
fit standard spouts having internal
or external threads. You will find
the adapter and two washers in the
"Hardware for Installation" packet
in your dishwasher.
To install faucet adapter, first
remove the old aerator or trim ring
on your faucet spout.
I
Insert the thinner of the two
washers into the faucet adapter and
attach it to the faucet spout.
If faucet has internal threads:
Insert both washers into the faucet
adapter and attach it to the faucet
spout.
If the faucet adapter threads do
not match your faucet spout, your
local hardware or plumbing supply
store normally has additiond fittings
to adapt your faucet spout to the
special aerator faucet adapter.
hose can burst if it is installed on
the same sink with yourdishwmhec
We suggest that you disconnect the
How to connect the
Unicouple
1. Pull Unicouple anditshoses from
storage compahent located at rear
of dishwasher and attach it to the
faucet adapter.
2. Attach the Unicouple connector
to the faucet adapter by depressing
collar at the top of the connector.
onto the adapter, release the collar.
It will then snap into position to
lock the Unicouple in place.
The Unicouple's smrdl hose carries
water from the faucet to the
dishwasher. Its large hose carries
drain water to the sink. Be sure drain
hose is pointing toward the sink bowl
drain opening and the sink drain is
open for water that will drain from
your dishwasher. If your dishwasher
drains into a disposer, operate the
disposer untfl it is completely empty
before starting the dishwasher.
3. fimhot water fully on before
starting the dishwasher.
How to use the
The Faucet-Flo nozzle is part of the
Unicouple connector. Operate the
nozzle by depressing the pressure
release lever on the side of the
Unicouple connector. You will find
the Faucet-Flo nozzle useful for
several reasons. For example:
12
It allows you to flush cold water
out of the hot waterline so that you
can better regulate your water
temperature.
It allows you to test the
temperature of the water before
starting your dishwasher.
If you need freshwater for
personal use:
Disconnect the Unicouple.
Draw your fresh water direcdy
from your faucet.
Do not disconnwt the Unicouple
while the dishwasher is operating.
How to disconnect the
Unicouple from faucet
1. Tumoffthehotwater.
2. Release thewaterpressureby
depressing the pressure release
lever. This relieves water pressure
and protects you, and the room,
from severe splashing.
3. Release Unicouplefiomfaucet by
depressing the collar at the top of the
Unicouple connector.
1. Remove thepowercordplug
from the wall rweptacle.
2. Disconnect Unicouple from
faucet adapter.
3. Shake excess water out of
Unicouple and return it and its
hoses to the dishwasher storage
compartment.
end of the find rinse, the Unicouple
can be disconnected and returned
to storage.