ZyXEL Communications P-2302HWUDL-P1 Support Notes page 83

802.11g wireless voip station gateway with dect base station
Hide thumbs Also See for P-2302HWUDL-P1:
Table of Contents

Advertisement

Each field's detail description is listed below.
Label
Description
Phone
Port
Use this field to select the phone port that you want to configure.
Settings
Speaking
Use this field to set the loudness that the ZyXEL Device uses for the speech
Volume
signal that it sends to the peer device. -1 is the quietest and 1 is the loudest.
Listening
Use this field to set the loudness that the ZyXEL Device uses for the speech
signal that it receives from the peer device and sends to your phone. -1 is the
Volume
quietest and 1 is the loudest.
G.168 Active Select this check box to cancel the echo caused by the sound of your voice
reverberating in the telephone receiver while you talk.
Fax Option
This field controls how the ZyXEL Device handles fax messages.
G.711 Fax
Select this if the ZyXEL Device should use G.711 to send fax messages. The
peer devices must also use G.711.
Passthrough
T.38
Fax
Select this if the ZyXEL Device should send fax messages as UDP or TCP/IP
Relay
packets through IP networks. This provides better quality, but it may have
interoperability problems. The peer devices must also use T.38.
Dialing
Enter the number of seconds the ZyXEL Device should wait after you stop
Interval
dialing numbers before it makes the phone call. The value depends on how
quickly you dial phone numbers.If you select Active Immediate Dial in VoIP
Select
> Phone > Common, you can press the pound key (#) to tell the ZyXEL
Device to make the phone call immediately,regardless of this setting.
Select this check box to use Voice Activity Detection (VAD) to reduce the
VAD
bandwidth that a call uses. The ZyXEL Device will generate and send comfort
Support
noise when you are not talking.
When you are dialing a telephone number the ZyXEL Device waits this long
after you stop pressing the buttons before initiating the call. Select how many
Dialing
seconds you want the ZyXEL Device to wait after the last input on the
Interval
telephone's keypad before dialing (making) a call.
Apply
Click Apply to save your changes back to the ZyXEL Device.
All contents Copyright  2007 ZyXEL Communications Corporation.
P2302HWUDL-P1 Support Notes
83

Advertisement

Table of Contents
loading

Table of Contents