Introduction Of Voip Trunking General Configuration - ZyXEL Communications P-2302HWUDL-P1 Support Notes

Introduction of VoIP Trunking General Configuration

To start using VoIP Trunking Gateway, the user has to activate this function by selecting Enable
Trunking from web GUI VoIP > Trunking > General.
LABEL
Enable Trunking
Auto Attendant
Timeout (Sec.)
Dialing
Interval (Sec.)
Enable Auto
Attendant
Authentication
Password
(Max. 32 digits)
Select this to turn on VoIP trunking on your ZyXEL Device.
This setting determines how long the ZyXEL Device waits for a caller to
enter a phone number when it receives the call.
Enter the number of seconds before the Auto Attendant times out.
The default value is 10 seconds and entering 0 does not change the default.
Enter a value from 1 to 255 seconds. When the auto attendant times out, the
incoming call will be directly relay to the analog phone connected on the
ZyXEL Device FXS port(s) via rings.
Enter the number of seconds the ZyXEL Device should wait after you stop
dialing numbers before it makes the phone call. The value depends on how
quickly you dial phone numbers. The default value is 3 seconds and
entering 0 does not change the default. Enter a value from 1 to 255 seconds.
Select this to enable authentication for calls coming into your ZyXEL
Device. Once this feature is enabled, the callers must enter the PIN to
forward calls via your ZyXEL Device.
This is the PIN callers have to enter via their phone pad when dialing into
your ZyXEL Device to forward calls through it.
All contents Copyright  2007 ZyXEL Communications Corporation.
P2302HWUDL-P1 Support Notes
DESCRIPTION
105