Samsung SNP-6200 User Manual page 93

To make recording on the SD memory
1. Check the <Total size> and the <Free size>.
2. If the SD memory has a sufficient free space, set <Record> to <On>.
Otherwise, check the stored data and if you find them not important, then click
<Format> to format the SD memory.

If your SD memory card writes slowly, only one frame per second will be stored.

For a SD memory card with a large capacity, the formatting will be slowed down accordingly.

If the size of data grows with time, only 1 fps can be stored even if you set the record quality to Full
Frame.

As some space of the SD memory card is reserved for the system, only about 90% of the total
capacity is available for use.
3. Specify the record conditions.
• Record profile : Display the number of profile to record.
• Overwrite : If the SD memory is full, this will delete old data and store new data in
replacement.
• Pre-alarm duration : Specify the saving time of the images before the alarm
occurs. You can specify up to 5 seconds before the occurrence of the alarm.
• Post-alarm duration : Specify the saving time of the images after the alarm
occurred. You can specify up to 120 seconds after the occurrence of the alarm.
• Normal : Make recording at a certain frame rate.
<Event> recordings are not saved as <Normal>.
• Event : Set the recording type for a certain event that occurs.
4. Specify the <Activation time>.
• Always : Always check if an alarm occurs. It activates in operated mode when the
alarm occurs.

If set to Always, the activation time cannot be changed.
• Only scheduled time : Check if an alarm occurs at a specified day of the week for
a specified time period. It activates in operated mode when the alarm occurs.
• [ ] : Reset all settings.
5. When done, click [Apply ( )].
English _93