Samsung SNP-6200 User Manual page 78

setup screen
WDR Setup
You can set to display a sharp image of the objects in a scene where both bright and dark
areas exist.
1. Select <Backlight>.
2. Set <Mode> to <WDR>.
3. Select each item and set it properly.
• WDR Limit : Specify the WDR
sensitivity level.

M
If WDR mode is active, the shutter mode
cannot be changed. Data transfer via the
network is available at up to 15 fps.

If the WDR mode is active, a moving
object can cause an afterimage on the
screen.

J
If the shutter mode is set to Manual or A.FLK, the WDR mode will be disabled.

If you select WDR, you may encounter the following problems. So set it to Not Used.
Unnatural change of colors that cause an unnatural image on the screen
-
- Noise on the bright area of the image

As the performance of the WDR function may differ depending on the bright-area size of the
image, it is recommended to optimize the installation angle for the best performance.

At night operation, this function will be activated only if the incoming highlight exceeds a certain
area in a low contrast environment.

Increasing the maximum value may cause an unnatural portion of the image.

For the best WDR performance, it is recommended to set the IRIS mode to AUTO.

If you select HLC, the auto focus operation may be repeated according to the lighting condition.
So it is recommended to set the focus mode to One Push AF or MANUAL.
78_ setup screen