Panasonic P-05D Instruction Manual page 104

Information
• You can also use packet communication when the Wi-Fi
function is enabled. However, Wi-Fi is given priority when
the mobile phone connects to Wi-Fi network. If the mobile
phone is disconnected from the Wi-Fi network, 3G/GPRS
network connection will automatically take over. Note that
packet communication fee will be charged if you continue
using the network connection.
• If connection to a Wi-Fi network is lost because, for example,
you are outside the service area, automatic connection after
re-entering the service area might take some time.
• When connecting to an access point you have selected, if you
enter an incorrect password (security key), [The access is
limited.] will be displayed. Verify the password (security key).
If [The access is limited.] is displayed even after you have
entered the correct password (security key), the correct IP
address might not have been obtained. Check the status of
the signal, and then try to connect again.
■
WPS
If an access point supports "WPS", some simple operations will
allow you to connect to the access point.
• For the push-button method, tap [WPS Button method] in step
3, and press the WPS button of the access point.
• For the PIN code method, tap [WPS PIN Code method] in step
3, and at the access point, enter the PIN code displayed on the
mobile phone.
■
Radio wave interference with Bluetooth devices
Wireless LAN (IEEE802.11b/g/n) and Bluetooth devices use the
same frequency band (2.4 GHz). As such, when using the mobile
phone near a Bluetooth device, radio wave interference may
occur, causing a drop in the communication speed and/or
resulting in noise or a connection failure. In cases like this, take
the following action.
• Place the Bluetooth device at least 10 meters away from the
mobile phone.
• If you must use the mobile phone within 10 meters of the
Bluetooth device, turn off the power of the Bluetooth device.
103 Initial Setting