Epson SureColor F7170 User Manual page 68

Heating & Drying
Set the temperature of the after heater.
Note:
Adjust Heater Temperature as follows:
❏ Set the heater to the temperatures recommended in the documentation provided with the
media, if available.
❏ Raise the temperature if the prints are blurred or smudged or the ink clots. Note, however,
that raising the temperature too high can cause the media to shrink, wrinkle, or deteriorate.
1. Use the d/u buttons to select Heating & Drying and press the Z button.
2. Use the d/u buttons to select the item you want to change.
Heater Temperature
(1) Select Heater Temperature and press the Z button.
(2) Use the d/u buttons to set the after heater temperature.
Drying Time Per Pass
(1) Use the d/u buttons to select Drying Time Per Pass and press the Z button.
(2) Use the d/u buttons to set the drying time.
When you want to maintain a constant drying time even when the print width changes, set the following value in accordance
with the media width.
A: Drying time (seconds)
Drying Time Guidelines by Media Width
Drying time in seconds
Blank Area Feed
(1) Use the d/u buttons to select Blank Area Feed and press the Z button.
(2) Use the d/u buttons to select the desired setting.
The following section shows the recommended setting values for Blank Area Feed according to the number of passes.
64 52 44 42
2.3 2 1.8 1.7
36 24
1.6 1.3
Basic Operations 68