Epson SureColor F7170 User Manual page 10

5 Roll core holder
Place an empty roll core for media take-up on these holders. There are two holders: one on the left and one on the right.
See"Media Loading and Take-Up" on page 48.
6 Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are two locking
screws: one on the left and one on the right.
7 Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports: one on the left and one
on the right.
8 Adjustment screw
Use the adjustment screw when performing parallel adjustment.
9 Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
10 Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in the Off
position.
11 Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the printer is in
use. If the stand fixing screw is lowered too much, the caster rises off the floor. Do not use the printer if a caster is off the floor.
12 Airflow vents
These vents release air from inside the printer. Do not obstruct the airflow vents.
13 Waste ink bottle (tank) holder
Place the waste ink bottle in this holder.
14 Stand fixing screw
In addition to locking the casters, the stand fixing screws also keep the printer securely in place. The stand fixing screws
cannot be used for horizontal adjustment of the printer. After installation, keep the printer securely in place during use.
15 Waste ink bottle (tank)
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
16 Stopper
The stopper prevents splatter when waste ink is ejected. Fit the stopper onto the mouth of the waste ink bottle.
17 Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in use.
18 Ink tank
Holds ink used for printing.
19 Slider (chip holder)
See "Slider (chip holder)" on page 12.
20 Lock lever
Raise the levers to unlock the slider for removal when replacing the chip unit. Always lower the lock lever after inserting the
slider.
Introduction 10