Intended Use; Operation - Festool TI 15 Instruction Manual

The cordless impact screw driver is suitable for
tightening screw fittings and screwing in screws up
to the maximum dimension range stated, as well as
drilling into metal, wood, plastics and similar ma-
terials.
The device must not be used for applications which
require a precise/specific torque. When using the
device for applications which require a specific
torque or for which a maximum torque must not be
Festool battery packs
With the Festool cordless impact screw driver TI 15
all Festool battery packs from the BPS and BPC se-
ries can be used at the same voltage.
The battery pack is immediately ready for oper-
ation upon delivery and can be charged at any
time independently of its charge state without
shortening the service life.
Changing the battery pack [2]
Inserting battery pack
10

Intended use

exceeded, there is the risk of overspeeding or dam-
age to the screw or the workpiece.
The charger TRC 3 is designed for charging the bat-
tery packs listed.
The user shall be liable for damage and acci-
dents resulting from non-specified use; this
also includes damage and wear caused dur-
ing industrial continuous operation.

Operation

Removing battery pack
The capacity display [1-7] automatically displays
the charge state of the battery pack [1-2] when the
ON/OFF switch is actuated:
2
Charging battery pack [3]
Charge Festool battery packs only using an
original Festool chargerTRC 3.
The charger TRC 3 can be used to charge all Festool
battery packs of the BPS and BPC series. The
charger automatically detects the type of the in-
serted battery (NiCd, NiMH or LiIon). A micropro-
cessor controls the charging process in line with
2
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
Festool charger
1