Installing Power Supplies - Alcatel-Lucent OmniSwitch 10K User Manual

Chassis and Power Supplies

Installing Power Supplies

Orient the power supply so that the power cord socket is situated at the right of the power supply. Also,
1
for the power supply to seat properly, make sure that the handle is in the open (horizontal) position as
shown.
Slide the power supply back until its connector meets the chassis backplane.
2
When the power supply is fully seated, rotate the handle 90 degrees to the closed (vertical) position.
3
Tighten the captive screw, located at the top-left of the power supply's front panel.
4
Plug the power cord (provided) into the power supply's socket.
5
OmniSwitch 10K Hardware Users Guide August 2015
Chassis Power Budget
page 2-17