Installing Power Supplies - Alcatel-Lucent OmniSwitch 10K Getting Started Manual

Installing Power Supplies

1 Orient the power supply so that the power cord socket
is situated at the right of the power supply. Also, for the
power supply to seat properly, make sure that the handle is
in the open (horizontal) position as shown.
2 Slide the power supply back until its connector meets
the chassis backplane.
3 When the power supply is fully seated, rotate the
handle 90 degrees to the closed (vertical) position.
October 2010
4 Tighten the captive screw, located at the top-left of the
power supply's front panel.
5 Plug the power cord (provided) into the power supply's
socket.
6 Place the cord retainer bracket over the power supply.
Installing the Hardware 9