Cmm/Cfm Led Status Indicators; Power Save Mode - Alcatel-Lucent OmniSwitch 10K User Manual

Chassis Fabric Module (CFM)

CMM/CFM LED Status Indicators

LED
OK1
OK2
Control
Fabric
Temp
USB
LINK/ACT

Power Save Mode

By default, power save is enabled on OS10K switches. When power save mode is enabled, unneeded
power supplies are shut down to conserve energy. Only the power supplies required to provide N+1
redundancy remain on.
When power save mode is disabled, all available power supplies are switched on at all times.
To change power save mode status, use the powersupply powersave command.
Note. Because N+1 redundancy applies only to active power supplies, the switch will go down if power is
simultaneously lost to all active power supplies while this feature is enabled.
page 3-4
State
Green
Amber
Green
Amber
Green
Green Blinking
Amber
Amber Blinking
Green
Amber
Green
Amber Blinking
Amber
Green
Green
Green Blinking
Green
Green Blinking
Chassis Management and Fabric Modules
Description
Passed diagnostics
Failed diagnostics
Operational
Transitional state (e.g. downloading code)
CMM Processor is Primary
CMM processor is Secondary
CMM processor is not functioning correctly
CMM processor upgrade in progress
Fabric section is functioning correctly
Fabric section is not functioning correctly
Temperature is 0-40C
Temperature is 40- 45C
Temperature is over 45C
Power save features are active. Refer to
Mode"
below for additional information.
USB device is mounted
USB device is transferring data
Ethernet port link is enabled
TX or RX activity on Ethernet port
OmniSwitch 10K Hardware Users Guide
"Power Save
August 2015