Connections - FUNAI HD-B2735 Owner's Manual

E2B21BD_E2B28BD_EN.book Page 15 Monday, August 21, 2006 5:05 PM

Connections

Antenna
Cable
Signal
or
2
RF cable
(supplied)
1
RF cable
(not supplied)
Connections
Connecting to a TV
Connect the unit to a TV after considering the
capabilities of your existing equipment.
Before installation, unplug your TV and this unit.
Using the Scart
jack
1
Connect the antenna or cable to the
ANTENNA IN jack of this unit.
2
Connect the ANTENNA OUT jack of
this unit to the Aerial jack of your TV.
Use the supplied RF cable.
3
Connect AV1(TV) Scart jack of this
unit to the Scart jack of your TV. Use
a commercially available Scart cable.
Note
• If your TV does not have a Scart jack, use a
commercially available Scart adaptor or Scart / RCA
cable to connect.
• Connect this unit directly to the TV. If the A/V cables
are connected to a VCR, pictures may be distorted
due to the copy protection system.
• When changing the "Video Out" setting
("SCART(RGB)", "Component (Progressive)" or
"Component (Interlace)"), connect to a Video jack or
an S-Video jack on the TV. If the setting is changed,
for example, to "Component (Progressive)" or
"Component (Interlace)" while the scart cable is
connected to the TV, a distorted video signal may be
output.
To Aerial jack
Audio/Video cable (not supplied)
Scart/RCA cable
(not supplied)
Scart adaptor
(not supplied)
DIGITAL AUDIO OUTPUT COMPONENT
PCM/BITSTREAM VIDEO OUTPUT
IN IN
S-VIDEO
OUT
COAXIAL
Y Y P P /C /C P P /C /C
B B B B R R R R
L OPTICAL
R
OUT AV2 ( DECODER )
AV2 ( DECODER )
ANALOG
AUDIO OUT
ANTENNA
15
3
Scart cable (not supplied)
AV1 ( TV ) AV1 ( TV )
Selecting Progressive Scan (625p <525p> or
Interlaced 625i <525i>) Playback
• If your TV is compatible with progressive scanning
(625p <525p>), connect the TV to the
COMPONENT VIDEO OUTPUT jacks of the unit
and set "Video Out" setting to "Component
(Progressive)" in the setup menu (see page 75).
Next, set your TV to the progressive scan mode.
• If your TV is not compatible with progressive scan,
set "Video Out" setting to "Component (Interlace)".
• Use a commercially available adaptor if the Video
input jacks of your TVs or monitors are the BNC
type.
Using the S-VIDEO OUT or the COMPONENT
VIDEO OUTPUT jacks and the ANALOG
AUDIO OUT jacks
If your TV has an S-Video or a Component Video
input jack, use either an S-Video cable (to connect the
S-VIDEO OUT jack) or a Component Video cable (to
connect the COMPONENT VIDEO OUTPUT jacks),
and an Audio cable (to connect the ANALOG AUDIO
OUT jacks).
- S-Video connection provides the good quality
picture.
- Component connection provides the better quality
picture.
1
Follow steps 1 and 2 on the left.
2
Connect S-VIDEO OUT or
COMPONENT VIDEO OUTPUT jacks
of this unit to the S-Video or
Component Video input jacks of your
TV. Use a commercially available
S-Video cable or Component Video
cable.
3
EN