Installing Batteries In The Remote Control; Hdd / Dvd Modes Switching - FUNAI HD-B2735 Owner's Manual

01_14_Introduction_EN.fm Page 12 Tuesday, August 22, 2006 1:41 PM
Installing batteries in the remote
control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
1
2
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the + and - ends of each battery
match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions
for environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the remote control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
Within about
7 m
30˚
Remote control
• The maximum operable range as follows:
Line of sight:
Either side of centre: approximately 5 m
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
EN
3
OP
EN
CL /
OS
E
HD
D &
DV
D- R
/ DV
D-
RW
RE CO
RD
IN
G
HD
D
DV
D
ST
OP
PL
AY
RE
C
ST
AN
D-
BY
ON
30˚
Within about
5 m
approximately 7 m

HDD / DVD modes switching

Because this unit is a combination of a HDD and a
DVD recorder, you must first select which component
you wish to operate.
Device Select Buttons / Indicators
OPEN/
CLOSE
HDD & DVD-R / DVD-RW RECORDING
DVD button / indicator
HDD DVD
HDD button / indicator
HDD button
DVD button
HDD mode
Press [HDD] on the remote control.
(Verify that the HDD indicator is lit.)
DVD mode
Press [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Note
• Pressing the device select button on the front
panel DOES NOT switch the device mode of the
remote control. You MUST select the correct
device mode on the remote control.
• If you press [REC] of each device, recording starts
in its device mode.
12
HDD DVD
STOP PLAY REC STAND-BY ON
TIMER INPUT
STANDBY-ON PROG. SELECT OPEN/CLOSE
.@/ : ABC DEF
PROG.
GHI JKL MNO
SATELLITE
PQRS TUV WXYZ
LINK
CHAPTER
MARK SPACE SYSTEM
TIME
SHIFT SETUP AUDIO CLEAR
DISC MENU TOP MENU
ENTER
DISPLAY RETURN
VARIABLE VARIABLE
SKIP REPLAY SKIP
REV PLAY FWD
STOP
PAUSE HDD DVD
REC MODE REC
1.3x/0.8x
REPEAT SEARCH PLAY DUBBING
MODE SELECT