The functions assigned to the following control input terminals (contact input: ⇒ Refer to Section 7.2) are always
activated regardless of the settings of the command mode selection and frequency setting mode selection 1
.
• Reset terminal (default setting: RES, valid only for tripping)
• Power removal terminal (assigned to PWR by default)
• Emergency stop terminal
To make changes in the command mode selection and the frequency setting mode selection 1 first
stop the inverter temporarily.
No change can be made to them if the inverter is in operation.
Preset speed operation
: Set this parameter at (terminal board).
: Any setting is valid.
1) Setting the run, stop and operation frequencies with the operation panel
Title
5
Power
supply
Function
Example of setting
(Operation
Command mode selection
panel input)
Frequency setting mode
(Operation
selection 1
panel input)
U/T1
R/L1
S/L2
V/T2
T/L3
W/T3
F
Inverter
R
PWR
Shorted by a shorting bar when
shipped from the factory.
P24/PLC
CCA
RX VI/II RR/S4 PP
Run/stop :Press the
on the operation panel
To switch between forward run and reverse run,
use the forward/reverse run selection .
Speed command :Press the
Motor
IM
E-8
E6581386
and
keys
RUN
STOP
and
keys on the operation
panel to set the frequency.
To save the frequency, press
the ENTER key. Then,
and the set frequency are
displayed alternately for a
while.