5.4
Setting parameters by operating method
: Automatic function setting
• Function
Automatically programs all parameters (parameters described below) related to the functions by
selecting the inverter's operating method.
The major functions can be programmed simply.
[Parameter setting]
Title
Function
Automatic function
setting
Automatically programmed functions and parameter set values
Default
:
Disabled
setting
:Terminal
–
board
–
:RR/S4
:Voltage
–
input
:Standby
–
:Preset
speed
–
(S3)
command 3
:/
–
terminal
switching
%
–
:VI/II
–
⇒ Refer to Section 11 for input terminal functions.
Disabled (=)
No change is made to the parameter setting.
Frequency setting by means of voltage: (=)
Operation is performed by applying a voltage for setting the RR/S4 terminal 1 frequency.
When sink logic is selected:
PWR-P24/PLC ON:
F-CC ON:
Forward run
R-CC ON: Reverse run
Frequency setting by means of current (=)
This setting is used to set the frequency by applying a current of 4-20mA to the VI/II terminal.
PWR-P24/PLC ON:
Standby (ON (short-circuited) by default)
F-CC ON:
Forward run
R-CC ON:
Reverse run
Voltage/current switching by means of an external terminal (=)
Switching between remote and local (different frequency commands) can be performed by turning on or off the S3 terminal. In
that case, apply a voltage via the RR/S4 terminal and a current via the VI/II terminal.
S3-CC OFF: The frequency is set according to the voltage applied to the RR/S4 terminal.
S3-CC ON: The frequency is set according to the current applied to the VI/II terminal.
In sink logic mode: PWR-P24/PLC ON: Standby (ON (short-circuited) by default), F-CC ON: Forward run, R-CC ON: Reverse run.
:Disabled
:Frequency setting by means of voltage
:Frequency setting by means of current
:Voltage/current switching from external terminal
:Frequency setting on operation panel and operation by means of terminal
:Frequency setting and operation on operation panel
:Coast stop
:
:
Frequency
Frequency
setting by
setting by means
means of
of current
voltage
–
–
:RR/S4
:VI/II
–
:Current input
–
–
–
–
:/
:/
terminal
terminal
switching
switching
–
%
:RR/S4
:VI/II
Standby (ON (short-circuited) by default)
Adjustment range
:
:
Voltage/current
Frequency setting
switching from
on operation panel
external terminal
and operation by
means of terminal
:Terminal
–
board
:Operation
:RR/S4
panel
:Current input
–
–
–
:Frequency
–
priority switching
:/
:/
terminal
terminal
switching
switching
%
–
:Operation
:VI/II
panel
E-5
E6581386
Default setting
:
:
Frequency
Coast stop
setting and
operation on
operation panel
:Operation
–
panel
:Operation
–
panel
–
–
:No
–
function is
assigned
–
:Standby
:/
terminal
–
switching
–
–
:Operation
–
panel
5