Open Network Option; My Function - Toshiba VF-PS1 Instruction Manual

Title
 Block read data 1
 Block read data 2
Block read data 3

Block read data 4

 Block read data 5
Free notes

* : No action .... No action is taken even if a timeout occurs.
Alarm ......... An alarm goes off if a timeout occurs.
The message "" blinks at the left end of the operation panel.
Trip ............. The inverter trips when a communication time-over occurs.
The message "" blinks on the operation panel.
Note: Changes to the parameters , and  do not take effect until the power is turned off and
then on again.

6.34.2 Open network option

 ~  : Communication option settings 1 to 7
 ~  : Communication option settings 8 to 13



 ,  : Selection of monitoring

⇒ For details, refer to Instruction Manual (E6581281, E6581343) specified in Section 6.36.
6.35

My function

 : Input function target 11~  : My function selection
⇒ For details, refer to Instruction Manual (E6581335) specified in Section 6.36.
Function
: Disconnection detection extended time
: Inverter operation at disconnection
: Preset speed operation selection
: Number of motor poles for communication
F-77
Adjustment range
:Deselect
:Status information
:Output frequency
:Output current
:Output voltage
:Alarm information
:PID feedback value
:Input terminal board monitor
:Output terminal board monitor
:VI/II terminal board monitor
:RR/S4 terminal board monitor
:RX terminal board monitor
:Input voltage (DC detection)
:Speed feedback frequency
:Torque
:MY monitor 1
:MY monitor 2
:MY monitor 3
:MY monitor 4
:Free notes
:Rotational speed
Ditto
Ditto
Ditto
Ditto
~
E6581386
Default setting






6