LG DLGX5681V Owner's Manual page 39

TROUBLESHOOTING 39
Before Calling For Service (cont.)
Problem Possible Causes Solutions
There are no • The function of this cycle is to • Use an iron to make creases
creases left on remove wrinkles from fabric,
garment after
Steam Fresh
TM
Garments have .This is normal • Depends on individual moisture level in skin
static after
Reduce Static
Garments are • Correct drying options not • Select load weight manually before starting Reduce Static
too damp or selected option
too dry after
Reduce Static
Garments are not • Number of garments or load • Select the correct number or garments or load size before
uniformly damp size not properly selected at the starting the cycle,
after Easy Iron beginning of the cycle
Water drips • This is normal • Condensation will normally form on the inside of the
from door dryer door during steam operation, Some condensation
during Steam may drip out the bottom of the door
Cycle
Steam is not • This is normal • Steam vapor is difficult to see when the door is closed,
visible during However, condensation will normally form on the inside of
Steam Cycle the dryer door if the steam system is operating normally,
Drum does not • This is normal. • The drum is turned off so that the steam vapor remains in
turn during the drum The drum will normally turn for about 2 seconds
Steam Cycle once a minute.
Cannot see • This is normal. • Steam is released at different stages of the cycle for each
steam vapor at option.
the beginning
of cycle
The display • More Time button pressed • This display indicates that the steam option has been set
shows for a" bl _" item such as a comforter.
Press the Less Time button to reduce the indicated load
bl o
_ l size,
Odors remain , Steam Fresh
TM
did not remove • Fabrics containing strong odors should be washed in a
in clothing after odor completely, normal cycle,
Steam Fresh
TM
, Lint filter is almost clogged or • Pause tile drying cycle and clean the lint filter,
full.
• Install a shorter or straighter duct run. See tile Installation
Instructions
Check Filter
light is on
during the
drying cycle
Flow Sense
TM
indicator
shows four
bars during the
drying cycle
• Ductwork is too long or has too
many turns/restrictions.
• Significant blockage of the
ductwork due to lint buildup or
debris,
• The appliance has detected a
restriction in the external dryer
venting,
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the How Sense
TM
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
Power button will turn offthe display.