Installing The Network Daughter Card; Processors; Removing A Processor - Dell PowerEdge R630 Owner's Manual

5. network daughter card

Installing the network daughter card

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the #1 Philips screwdriver handy.
CAUTION: If the GPU card is installed, you cannot install the 10 GbE network daughter card.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: If the server has three PCIe cards, ensure that you install the PCIe cooling shroud in your
system.
Steps
1. Angle the card so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. Press the touch point on the card to ensure that the connector on the card is in contact with the
connector on the system board.
4. Using a #2 Phillips screwdriver, tighten the two captive screws to secure the network daughter card
to the system board.
5. Install the expansion-card riser 3.
Next steps
Follow the procedure listed in

Processors

Use the following procedures when:
• Installing an additional processor
• Replacing a processor
NOTE: To ensure proper system cooling, you must install a processor blank in any empty processor
socket.

Removing a processor

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
94
Safety instructions.
Before working inside your
After working inside your
6. back panel slots for Ethernet
connectors
system.
system.