Installing The Network Daughter Card - Dell EMC E39S Series Installation And Service Manual

Figure 74. Removing the network daughter card
Next steps
Install the Network Daughter

Installing the network daughter card

Prerequisites
Follow the safety guidelines listed in
Steps
1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Figure 75. Installing the network daughter card
Card.
Safety instructions on page 71.
Installing and removing system components 129