Table of Contents
Advertisement
Steps
1.
Remove the expansion-card riser 3.
2.
Using a #2 Phillips screwdriver, loosen the two captive screws that secure the network daughter card
to the system board.
3.
Hold the network daughter card by the edges on either side of the touch points and lift to remove it
from the connector on the system board.
4.
Slide the network daughter card away from the back of the system until the Ethernet connectors are
clear of the slot in the back panel.
5.
Lift the network daughter card out of the system.
Figure 26. Removing and installing the network daughter card
1.
captive screw socket (2)
3.
captive screw (2)
5.
network daughter card
Installing the network daughter card
Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
Safety
instructions.
Before working inside your
2.
connector on the system board
4.
touch point (2)
6.
back panel slots for Ethernet
connectors
system.
73
Advertisement
Table of Contents
Troubleshooting
