Using A Bi-Amplifier Connection - Sony STR-DA5300ES Operating Instructions Manual

Using a bi-amplifier
connection
I I' you are not usi ng surround back speakers,
you can use the SURROUND BACK
SPEAKERS terminals for the front speakers
for usc with a bi-amplifier connection.
To connect speakers
Notes
• You cannot use the FRONT SPEAKERS B jacks
for a bi-ampliller connection.
• When you usc the auto calibration function. make
the bi-amplilier settings before you perform auto
cal ibration.
'11' you make the bi-amplitler settings, the speaker
level, balance, and equalizer settings of the
surround back speakers become invalid, and those
of the front speakers are used.
• Signals output from the PRE OUT jacks are used
with the same settings as those of the SPEAKERS
terminals.
Front speaker
(R)
Frontspeaker
(L)
~~)(~)
0
00
La
Connect the jacks on the Lo (or Hi) side of the
front speakers to the FRONT SPEAKERS A
jacks, and connect the jacks on the Hi (or Lo)
side of the front speakers to the SURROUND
BACK SPEAKERS terminals. Make sure that
metal fittings of Hi/Lo attached to the speakers
have been removed from the speakers. Not
doing so may cause a malfunction of the
receiver.
To set up speakers
Set "Sur Back Assign" to "BI-AMP" in the
Speaker settings menu. The same signals
output from the FRONT SPEAKERS A jacks
can be output from the SURROUND BACK
SPEAKERS terminals by setting "Sur Back
Assign" to "BI-AMP."
..
o
-
J
(1)
~
o
"
(1)
~
III
-
O ·
::s
UI
113 GB