Sony STR-DA5300ES Operating Instructions Manual page 51

Message list after auto calibration measurement
..
Display
Code 30
Code 31
Code 32
Code
:n
Code 34
Warning 40
Warning 41
Warning 42
Warning 43
Warning 44
Explanation
Headphones are connected. Remove the headphones and perform the auto calibration again.
SPEAKERS
(Ol-'I-'/A/B/A+B)
is set to
01-'1-'.
Set it to others and re-perfonn the measuremenl.
None of the speakers were detected. Make sure that the optimizer microphone is connected
properly and reperfonn the measurement.
If the optimizer microphone is connected properly but the error code appears, the optimizer
microphone cable may be damaged or improperly connected.
• None of the front speakers are connected or only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speakers is not connected.
• Surround back speakers arc connected even though surround speakers are not connected.
Connect the surround speaker(s) to the SURROUND terminals.
• The surround back speaker is connected only to the SURROUND BACK SPEAKERS R
terminals. When you connect only one surround back speaker. connect it to the
SURROUND BACK SPEAKERS L terminals.
Speakers are not placed in the proper position. Speakers or an optimizer microphone on the
right or left may be placed wrongly. See" I: Installing speakers" (page 16) and check the
speaker position.
The measurement has completed. However, the noise level is high. You may be able
to
perform the measurement properly if you try it again, even though the measurement cannol
be performed in all environments. Try to perform the measurement in a quiet environment.
The sound input from the optimizer microphone is outside the acceptable range. It is louder
than the loudest sound that can be measured. Try to perform the measurement when the
environment is quiet enough
10
allow proper measurement.
The volume of the receiver is out of the acceptable range. Try to perform the measurement
when the environment is quiet enough to allow proper measurement.
The distance and position of a sub woofer cannot be detected. Or the angle of the speaker
position cannot
be
detected. This may be caused by noise. Try to perform the measurement
in a quiet environment.
Measurement has been completed. However the speakers are not placed in the proper position
with respect to each other. Sec" I: Installing speakers" (page 16) and check the relative
positions of the speakers.
G)
111
8=.
::::l
lQ
en
iii
...
-
1 11
Co
NO WARNING There is no warning information.
No speakers arc connected.
-Code 31
1
Press
8,
then follow the instructions from step
I of "Performing auto calibration."
-Code 32,33,34
1
When you press
8,
"Retry'!" appears.
2
Press +1+ to select "Yes," then press
8.
3
Follow the instructions from step 2 of
"Performing auto calibration."
When you select "WRN CHECK"
If a warning on the measurement result is
present, detailed information is displayed.
Press
8)
to return to step 1 of
"Confirming/saving the measurement
results" (page 49).
continued------
51 GB