Masonry Fireplace Requirements; Zero-Clearance (Metal) Fireplace Requirements; Leveling Bolt Installation - Lopi Answer Owner's Manual

M F
ASONRY IREPLACE
¥ Chimney must have a clay tile liner or a stainless steel liner (positive connection)
¥ Entire fireplace, including chimney, must be clean and undamaged. Any damage must be
repaired prior to installation of the insert
¥ Chimney height: 15' minimum; 33' maximum.
¥ Entire fireplace, including chimney, must meet local building requirements
Z -C
ERO LEARANCE
¥ Must utilize a positive (full reline) or direct connection (block-off plate)
¥ Must be manufactured by one of the following manufacturers:
¥ Marco
¥ Entire fireplace, including chimney, must be clean and undamaged. Any damage must be
repaired prior to installation of the insert
¥ Entire fireplace, including chimney, must meet local building requirements
¥ Chimney height: 15' minimum; 33' maximum. Minimum cross section: 28.65 square inches
¥ The damper ("
removed (see the illustration to the right)
¥ The smoke shelf ("
(" "), screen ("
D
doors (" ") may be removed (if applicable)
F
¥ The masonry lining ("
and any structured rigid frame members
(metal sides, floor, door frame, face of the
fireplace, etc. Ð "
altered
D P
RAFTING ERFORMANCE
This appliance relies upon natural draft to operate. External forces, such as wind, barometric pressure,
topography, or factors of the home (negative pressure from exhaust fans, chimneys, air infiltration, etc.),
may adversely affect draft. Travis Industries can not be responsible for external forces leading to less
than optimal performance.
L B I
EVELING OLT
Inside the accessory pack are a pair of leveling bolts used to level the insert if the fireplace has a
stepped-up hearth. To install, raise the rear of the insert up and insert the leveling bolts into the holes in
the rear corners of the insert. Screw the bolts down until they extend the same height as the hearth steps
up. After the insert is installed, fine-tune the leveling bolts to level the insert (see the illustration below).
This distance is the
hearth step-up.
The leveling bolts
should stick out
this far from the
base of the insert.
Hearth
R
EQUIREMENTS
(M ) F
ETAL IREPLACE
¥ Majestic ¥ Heatilator
") and grate (" ") must be
A B
"), internal baffles
C
"), and metal or glass
E
"), insulation ("
G
") may not be removed or
I
NSTALLATION
I
NSERT
R
EQUIREMENTS
¥ Preway
F
"),
H
Fireplace
I
NSTALLATION
:
¥ Tempco ¥ Superior
H
C
I
E
B
The leveling bolts
go into the holes in
the outer rear of the
insert baseplate.
(C .)
ONT
P 17
AGE
A
D
G