Table of Contents
Advertisement
Getting started
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the telephone base or charger
when not in use. The battery is fully charged after ten hours of continuous
charging. See the table on page 131 for battery operating times.
If the screen shows �lace in charger and
handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or
shows �lace in charger
and
(flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HAND�ET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
�tep 1
Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label THI� �IDE U�
facing up, as indicated.
Battery status
Battery has no or very
little charge. The handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
9
flashes, you need to charge the
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
Advertisement
Table of Contents
