Deregistering Handsets; Deregister All Handsets From The Telephone Base - AT&T CL83215 Complete User's Manual

Dect 6.0 cordless telephone/ answering system with caller id/call waiting
Hide thumbs Also See for CL83215:
Table of Contents

Advertisement

Appendix

Deregistering handsets

You may need to deregister your handsets if:
You have 12 registered handsets and need to replace a handset.
-OR-
You wish to change the designated handset number of your
registered handsets.
You must first deregister ALL handsets, and then register each handset you
wish to use again, one at a time.
�lease read carefully through all the instructions on this page before
beginning the deregistration process.

Deregister all handsets from the telephone base

In addition to the cordless handsets, this operation will also deregister all
cordless headsets and speakerphones registered to your telephone base.
1. Make sure that all handsets are out of the telephone
base and chargers before you begin deregistration.
2. Press and hold
telephone base for about ten seconds (until the
IN U�E light starts to flash). The telephone base screen
shows Registering... �lease wait for five seconds, then
it shows Deregister all devices?. Release
3. Immediately press
flashing. (If the light stops flashing, start again with Step 1.)
4. It takes up to ten seconds to complete the deregistration process. Before
registering the handset again, wait for the cordless handset screen to
display To register H�, see manual.
5. To register the handset(s) to the telephone base again, follow the
registration instructions on the previous page.
NOTES:
If the deregistration process fails, you may need to reset the system and try again. To reset,
unplug the power from the telephone base and plug it back in.
You cannot deregister the handsets if any other system handset is in use.
Even if the battery is depleted, you can still deregister the handsets by following the steps
mentioned above. After the handset is charged for at least ten minutes, the screen shows
To register H�, see manual.
If in Step 2 you already have 12 registered handsets, the telephone base shows Registration
slots are full and sounds two beeps. Continue holding
Deregister all devices? displays.
/HAND�ET LOCATOR on the
/HAND�ET LOCATOR while the IN U�E light is still
/HAND�ET LOCATOR.
/HAND�ET LOCATOR until
106

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cl83465Cl83415Cl83565Cl83315Cl83365

Table of Contents