Battery Installation & Charging - AT&T E2912B User Manual

Getting started
Battery installation & charging
After battery installation, the battery may have enough charge to allow you to make
a short call. For best performance, place the handsets in the telephone base or the
charger and allow to charge for 16 hours before use. You can keep the battery charged
by returning the handsets to the telephone base or the charger after use. When the
battery is fully depleted, a recharge takes about 12 hours. The average talk time on a
fully charged battery is about eight hours, and the standby time is approximately five
days. Actual battery life depends on usage conditions and age of battery.
1. Plug the small end of
the smaller power adapter
into the jack on the
underside of the charger,
then route the cord
through the slot as shown.
6. The battery may have enough charge
to allow you to make a short call. For best
performance, place the handset in the tel-
ephone base or charger to charge for at
lease 16 hours before first use.
Caution: Use only the supplied rechargeable battery or replacement battery model 27910
(part number 89-0099-00-00).
2. Plug the large
end of the smaller
power adapter into
an electrical outlet
not controlled by a
wall switch.
3. Insert the plug as indicated.
Be sure to securly insert the
plug, making sure matches
the color-corded label inside
the battery compartment.
LOW BATTERY
Low battery indicator
Return the handset to the
telephone base or charger
to recharge when this sym-
bol flashes. (Handset will
beep when battery is low.)
4. Place the
battery pack
and wires
inside the
compartment.
To replace the battery, press in and downward
on the tab of the battery compartment to open
the battery compartment cover. Lift out the
out the old battery and disconnect it from the
handset. Follow the instructions on this page to
install and charge the new battery.
8
5. Slide the bat-
tery compart-
ment cover up
until it clicks.