Battery Installation And Charging - AT&T GL2101-0 User Manual

Getting started

Battery installation and charging

Install the battery, as shown on page 11. Once you have installed
the battery, the screen indicates the battery status (see the
following table). If necessary, place the handset in the telephone
base or charger to charge the battery. For best performance, keep
the handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See
the table on page 37 for battery operating times.
If the screen is blank or shows Put in charger and a flashing , you
need to charge the handset without interruption for at least 30
minutes to give the handset enough charge to use the telephone
for a short time. When the battery is low, the handset shows Low
battery and a flashing . If you are on a call in low battery mode,
the handset beeps every minute.
The following table summarizes the battery charge indicators and
actions to take.
Battery indicators
The screen is blank or
shows Put in charger
and flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
Battery status
The battery has no or
very little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
10
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone
base or charger when not
in use.