Set Up A Vpn Connection; Specify Vpn Service In The Modem Router - NETGEAR Nighthawk D7000 User Manual

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000

Set Up a VPN Connection

A virtual private network (VPN) lets you use the Internet to securely access your network when you are
not home. This type of VPN access is called a client-to-gateway tunnel. The computer is the client, and
the modem router is the gateway. To use the VPN feature, you must log in to the modem router and
enable VPN, and you must install and run VPN client software on the computer.
Note The modem router does not support iOS or Android VPN client software.
VPN uses DDNS or a static IP address to connect with your modem router.
To use a DDNS service, register for an account with a host name (sometimes called a domain name).
You use the host name to access your network. The modem router supports these accounts: NETGEAR,
No-IP, and Dyn. See Set Up and Manage Dynamic DNS
If your Internet service provider (ISP) assigned a static WAN IP address (such as 50.196.x.x or 10.x.x.x)
that never changes to your Internet account, the VPN can use that IP address to connect to your home
network.

Specify VPN Service in the Modem Router

You must specify the VPN service settings in the modem router before you can use a VPN connection.
To specify the VPN service:
1. Launch an Internet browser from a computer or WiFi device that is connected to the network.
2. Type http://www.routerlogin.net.
A login window opens.
3. Enter the modem router user name and password.
The user name is admin. The default password is password. The user name and password are
case-sensitive.
4. Click the OK button.
The BASIC Home page displays.
5. Select ADVANCED > Advanced Setup > VPN Service.
The VPN Service page displays.
6. Select the Enable VPN Service check box.
Use VPN to Access Your Network
268
on page 193.