Bluetooth Player; Wifi; Fig. 17 - Skoda Infotainment Columbus Operating Instructions Manual

Charge USB audio source
With the ignition on after connecting the USB audio source, the charging proc-
ess is automatically started (applies for audio sources where charging via the
USB connector is possible).
The charging efficiency can be different compared to the charging from the
usual mains power supply. Connected audio sources can be supplied / loaded
with a current of max. 1.5 A.
Some connected audio sources may not be recognised and cannot be charged.
CAUTION
USB extension cords, or reducers may impair the function of the connected au-
dio source.
Note
We recommend that you use extension cords from ŠKODA Original Accesso-
ries.
®
Bluetooth player

Read and observe and
The unit allows audio files of a connected Bluetooth
A2DP and AVRCP audio profile.
®
Connect the Bluetooth player
›
Connect the player to the device - follow the same instructions as for pairing
the device with a telephone » page
›
Select the audio source  BT audio
the desired player.
®
Separate the Bluetooth player
›
Terminate the connection in the list of paired devices
If an Apple device is connected as a Bluetooth
the USB input, then the Bluetooth
The following warning message appears in the screen Bluetooth-Audio
(A2DP) ... Connection cancelled.
on page 26 first.
®
player to play using the
43.
» page 23, Select audio source and then
» page 45.
®
player, and this is connected to
®
connection is dropped.

WIFI


Read and observe and
The device allows you to play audio files connected from a WLAN device to the
device.
Play over WLAN
›
Connect the player to the device's WLAN
device WLAN (WLAN hotspot).
›
Start the UPnP application in the connected device.
›
Select the audio source  WLAN
AUX - input

Read and observe and
The AUX input can be found in the stowage compartment of the front centre
console » Fig. 17.
An audio source connected to the AUX input cannot be operated from this
unit.
Connecting AUX audio sources
›
Insert the plug of the audio source in the corresponding well.
›
Select the audio source
 AUX » page 23, Select audio source.
›
Start playback on the connected audio source.
Disconnect AUX audio source
›
Disconnect the connector of the audio source.
on page 26 first.
» page 54, Connection with the
» page 23, Select audio source.

Fig. 17

AUX input
on page 26 first.

29
Media