Completing The Setup Program - Cisco Catalyst 3560-CX User Manual

Completing the Setup Program

Completing the Setup Program
If your switches are stacked and there are multiple console connections to individual switches in the stack,
the initial setup dialog box appears at the console where you first press Enter.
SUMMARY STEPS
1. Enter Yes at these two prompts:
2. Enter a host name for the switch, and press Return.
3. Enter an enable secret password, and press Return.
4. Enter an enable password, and press Return.
5. Enter a virtual terminal (Telnet) password, and press Return.
6. To configure the country code, enter yes and press Return.
7. Enter the country code, and press Return.
8. (Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. You
can also configure SNMP later through the CLI, Device Manager, or the Network Assistant application.
To configure SNMP later, enter no.
9. Enter the interface name (physical interface or VLAN name) of the connection to the management network,
and press Return. For this release, always use vlan1 as that interface.
10. Configure the interface by entering the switch IP address and subnet mask and pressing Return. The IP
address and subnet masks shown are examples.
11. Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member switch
or as a standalone switch.
12. From these choices that appear, make your selection and press Return.
DETAILED STEPS
Step 1
Enter Yes at these two prompts:
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Step 2
Enter a host name for the switch, and press Return.
Catalyst 3560-CX and 2960-CX Switch Hardware Installation Guide
74
Configuring the Switch with the CLI-Based Setup Program