Cisco Catalyst 3560-CX User Manual page 24

Warnings
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct
Warning
hardware or to follow the correct procedures could result in a hazardous situation to people and damage
to the system. Statement 378
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
1001
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions
Warning
to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
Statement 1006
Warning Class 1 laser product. Statement 1008
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection: 10/100/1000 Ethernet.
Statement 1044
Catalyst 3560-CX and 2960-CX Switch Hardware Installation Guide
14
Switch Installation